ParaBody Leg Press 100 - Manual (Page 5)

11-1/4"
5
FIGURE 2
STEP 2:
• SECURELY assemble the SECOND ARM (5) to the FRAME (1) using one 1/2 X 5” BOLT (12), two 3/4” FLANGE BEARINGS
(14), one 3/4 X 4” SHAFT (17) and one 1/2” LOCK NUT (13). See FIGURE 2.
• SECURELY assemble the MAIN ARM (4) to the FRAME (1) using one 1/2 X 5” BOLT (12), two 3/4” FLANGE BEARINGS (14),
one 3/4 X 4” SHAFT (17) and one 1/2” LOCK NUT (13). See FIGURE 2. (NOTE: Make sure MAIN ARM is orientated cor-
rectly, top hole should be 11-1/4” from the top of arm as shown in FIGURE 2.)
• NOTE: Follow STEP 2 for the assembly of the LEG PRESS to the 777 Gym System. If you have the 220 or 880 Gym Systems
proceed to STEP 3.
• Proceed to to STEP 3.
• SECURELY assemble two 1” SQ. GLIDES (18) to each side of the MAIN ARM (4) where the MAIN ARM (4) contacts the FRAME
(1) See FIGURE 2.
12 1/2 X 5”
1 13
17
14
4
5
18
For assembly to the the 777 Gym System .
Make sure MAIN ARM
is orientated correctly