Precor Electronic M9.4 - Manual (Page 10)

page 10
12. Place the lift motor cover onto the lift motor. Using the four 3/8" screws
found in the hardware kit, securely attach the cover to the lift motor.
Photo 5 Secure lift
platform and lift
tube
13. Lay the treadmill on its right-hand side with the help of another person.
Note: Right and left are determined while standing behind the treadmill,
facing towards the front of the machine.
14. Locate the long shoulder bolt and 3/8" locknut in the hardware kit. Insert
the long shoulder bolt through the center of the lift platform and the lift tube.
Secure the lift platform and tube together by fastening the 3/8 " locknut to
the end of the shoulder bolt. Fully tighten the bolt with the hex key pro-
vided. (See Photo 5.)
15. Return the treadmill to an upright position, so it rests flat on the floor.
16. Replace the black hood that you removed in Step 1 and tighten the eight
phillips-head screws.
CAUTION: Precor recommends that two people move the treadmill to
its final location. A fully-assembled M9.4 treadmill is very heavy, and
might cause back strain if one person tries to move it.
17. If you need to move the treadmill, ask for assistance from another person.
Roll the treadmill on its front wheels to the new location by lifting the rear
end of the unit.
CAUTION: Do not remove or otherwise bypass the 3-prong plug with
an adapter in order to use a non-grounded outlet.
18. Plug the treadmill into a standard 120v household outlet. Make sure that no
other major appliances use the same circuit as the treadmill.
19. Continue to Checking the Alignment of the Running Belt to complete the
installation of the M9.4 treadmill.
Lift platform
Lift tube
Long shoulder bolt