Profoon Telecommunicatie TX-250(CW) - Manual (Page 17)

DECLARATION OF
NETWORKCOMPATIBILITY
The Profoon TX-250 is designed for use
on the ‘public switched telephone net-
works (analogue single-line)’ of telepho-
ne- and cable-companies inside the EU.
Each country and/or provider might
require a different telephoneplug.
The Profoon TX-250 complies with the
essential requirements and provisions
as described in the European Directive
1999/5/EC.
The functions Caller-ID and VoiceMail are
based on both the DTMF and the FSK
system (automatic detection).
It might be possible that you have to sub-
scribe to these features.
DECLARATION OF CONFORMITY
The declaration of conformity is available
on the website
WWW.PROFOON.COM
Attention:
TX-250: The display is powered by 4 pcs
battery, 1.5 Volt, size AAA. Batteries are
included. At wish you may also connect a
9V DC power adaptor (PROFOON
PCI-A9).
TX-250CW: The display is powered by
the included power supply.
INTRODUCTION
The Profoon TX-250 is a telephone with
built-in Caller-ID: the name (when sup-
ported by the provider or when stored
in the memory) and the number of the
person who is calling to you, comes on
the display of your telephone.
The Caller-ID memory has a capacity of
90 calls, including the time and date of
the call.
The Caller-ID is linked with the dialer of
the telephone. Any incoming call can be
called back.
The TX-250 has a memory of 13 frequent-
ly dialed numbers, a phonebook-memory
of 70 names with telephonenumber and
is a speakerphone.
INSTALLATION
BATTERIES:
Open the battery compartment (bottom-
side) and install 4 pcs 1.5V AAA batteries.
Attention: always disconnect the tele-
phone from the telephone outlet when
batteries are to be installed or replaced.
TELEPHONE- & HANDSETCORD:
1. connect the supplied handsetcord
between the handset and base
2. connect the telephonecord to the
backside of the telephone; push the
connectors till you hear a click
3. plug the telephone plug into your
telephone
outlet
17
GB