Parkside BELT PEBS 600 - Manual (Page 10)

11 GB/IE/CY
DaNGEr OF FIrE FrOM FLyING SParKS!
Do not use any form of dust extraction (dust box
5
or vacuum extraction device) if you are sanding metal.
Connection:
j Push the adapter for external vacuum extraction
12 into the adapter port 9 . If it is necessary to
use the reducer piece 13 , push the reducer
piece into the adapter for external vacuum ex-
traction
12 .
j Slide the hose of a suitable dust extraction de-
vice approved for that purpose (e.g. a workshop
vacuum cleaner) on to the adapter for external
vacuum extraction
12 with the reducer piece 13 ,
if used.
removal:
j Pull off the dust extraction device hose.
j Pull off the adapter for external vacuum extrac-
tion
12 (with the reducer piece 13 , if used).
Q
Operation
Q Switching on and off
When operating the belt sander you can select
between intermittent or continuous operation mode.
To switch on intermittent operation mode:
j Press the ON / OFF switch 3 .
To switch off intermittent operation mode:
j
Release the ON / OFF switch 3 .
To switch on continuous operation mode:
j Press the ON / OFF switch 3 , and keep it
pressed, then press the locking knob 4 .
To switch off continuous operation mode:
j Press and then release the ON / OFF switch 3 .
Q Selecting the correct rotational
speed and sanding belt
You can select the belt speed using the belt speed
adjuster wheel
1 even whilst the sander is running.
The optimum belt speed depends on the workpiece
and the workpiece material. Always confirm the
best speed by carrying out a small test. The follow-
ing table lists some recommended values to help
you determine the optimum speed.
Material / type of
work Softwood
Coarse finish
(Grit grade)
60
Fine finish (Grit grade) 240
Preselected rotation
speed
high (5-6)
Material / type of
work Hardwood
Coarse finish
(Grit grade)
60
Fine finish (Grit grade) 180
Preselected rotation
speed
high (5-6)
Material / type of
work Chipboard
Coarse finish
(Grit grade)
60
Fine finish (Grit grade) 150
Preselected rotation
speed
high (5-6)
Material / type of
work removing paint /
varnish
Coarse finish
(Grit grade)
60
Fine finish (Grit grade) ––
Preselected rotation
speed
high (5-6)
Preparing for use / Operation
30176_Bandschleifer_Content_LB6.indd 11 03.04.09 08:58