Connect power 1 – Philips CMQ205 User Manual
Page 7
Advertising
8
Connect power
1
Make the power connection as illustrated below:
Connect the ground wire from the car to the
•
GND socket.
Connect the remote wire from the car audio to the
•
REM socket.
With this connection, you can turn on/off the amplifier with the car audio.
•
Connect the power wire from the car battery to the
•
+12V socket.
Less than 450mm (18 in)
Fuse (40A)
+12V car battery
Car audio unit
Remote output
To a metal point of the car
(30A)
Tip
If your car audio does not have remote output, connect the remote input terminal (REM) to the accessory
•
power supply.
To avoid short circuit, cover the power socket with the supplied shield and screws after connected power
•
wires. See below illustration:
EN
Advertising
This manual is related to the following products: