Philips CMQ205 - Manual (Page 5)

6
3 Installation
Note
Follow all mounting and wiring instructions. •
Mount the amplifier in car
You can mount the amplifier either under a seat
or on the rear tray.
Note
To avoid interference, do not place the •
amplifier too close to the car audio or antenna.
The supplied mounting screws are 25mm long. •
Make sure that the mounting board is thicker
than 25mm.
1
Place the unit on the location for
installation.
2
Mark the positions of the four screw
holes.
3
Drill the holes with driller of
approximately 4mm in diameter.
4
Mount the unit with the supplied screws.
i FUSE: 30AX1
j POWER
To connect +12V-DC power wire, •
ground wire, and remote control
wire.
EN