Philips SC-BT735 - Manual (Page 22)

22
VQT2Q52
STEP 6:
Reprogramming the
remote control
When other Panasonic products respond to this
remote control
Change “Remote Control” (> 40) on the main unit and the
remote control (the two must match) if you place other
Panasonic products close together and it responds to this
remote control.
To change the code on the main unit.
1
While stopped, press [START].
2
Press [3, 4] to select “To Others” and
press [OK].
3
Press [3, 4] to select “Setup” and press
[OK].
4
Press [3, 4] to select “General” and press
[OK].
5
Press [3, 4] to select “Remote Control”
and press [OK].
6
Press [3, 4] to select the code (1 or 2) and
press [OK].
To change the code on the remote control.
1
While pressing [OK]
Press and hold the numbered button (1 or
2), which has the same number you
selected in the step 6 for more than 5
seconds.
2
Press [OK].
Inserting or removing a
media
≥ When inserting a media, ensure that it is facing the right way
up.
≥ While the reading indicator is displayed, do not turn off the
unit or remove the media. Such action may result in loss of
the media’s contents.
≥ When removing the SD card, press on the centre of the card
and pull it straight out.
≥ If you connect a Panasonic product with a USB connection
cable, setup screen may be displayed on connected
equipment. For details, refer to the instructions for the
connected equipment.
∫ To switch sources
Press [BD/SD] or [EXT-IN] to select “BD/DVD”, “SD” or
“USB”.
≥ If a media is inserted while the unit is stopped, the source
switches automatically depending on the inserted media.
SD CARD SETUP MIC
SCBT735_330_230EBEPEG_VQT2Q52-B.book 22 ページ ２０１０年２月９日 火曜日 午前１０時５１分