Panasonic BT-LT2600 - Manual (Page 12)

22
The underlined values are factory preset setting values.
*1 If these settings are changed, the menu settings will also change.
FUNCTION
Sub menu Settings Explanation
FUNCTION 1 –
FUNCTION 5
<HV DELAY>
<AUTOSETUP>
<BLUE ONLY>
<GAMMA SELECT>
<SD ASPECT>
<SCAN>
<SUB WINDOW>
<WFM>
<MARKER>
<PIXEL TO PIXEL>
<PIXEL POS.>
<LEVEL METER>
<MONO>
<UNDEF>
(Factory preset
settings
FUNCTION1:
MARKER
FUNCTION2:
WFM
FUNCTION3:
LEVEL METER
FUNCTION4:
PIXEL TO PIXEL
FUNCTION5:
PIXEL POS.)
Used to select the functions to be assigned to individual
buttons [FUNCTION1] to [FUNCTION5] (front-panel buttons).
<HV DELAY>
Displays the synchronizing signal (horizontal, vertical).
The display is switched in the following order.
DELAY OFF J V DELAY J H DELAY J HV DELAY J
DELAY OFF
<AUTOSETUP>
Used to automatically adjust the PC display.
<BLUE ONLY>
Used to cut the red and green signals. You can check the hue
(PHASE) and depth of color (CHROMA). This is switched
between ON/OFF by pushing the button.
<GAMMA SELECT>
Used to display the gamma curve.
The display changes in the following order.
GAMMA STANDARD J GAMMA FILM J
GAMMA STDIO/PST J GAMMA STANDARD
<SD ASPECT>
Used to switch between “16:9” and “4:3”.
*1
<SCAN>
You can switch between “UNDER SCAN” and “NORMAL
SCAN”.
*1
<SUB WINDOW>
You can perform the settings for 2 screen display mode. *1
The display changes in the following order.
SINGLE J FULL/PARTJ STILLJ SINGLE
<WFM>
Used to display the wave form monitor.
<MARKER>
Used to switch the marker on and off.
<PIXEL TO PIXEL>
Used to switch the display between the input size and display
size.
<PIXEL POS.>
Used to set the signal display position when PIXEL TO PIXEL
is on.
<LEVEL METER>
Used to switch the AUDIOMETER display.
The display changes in the following order.
METER 8CH J METER 4CH J METER 2CH J OFFJ
METER 8CH
<MONO>
Used to switch the display between color and black-and-
white.
<UNDEF>
No settings
FUNCTION DISPLAY
<ON>
<OFF> Used to make display settings for the functions assigned to
individual buttons [FUNCTION1] to [FUNCTION5] (front-
panel buttons).
<ON>
The selected function is displayed.
<OFF>
The selected function is not displayed.
Main Menu
(continued)