ProForm CardioCross Trainer PFEL2605.0 - Manual (Page 4)

To hire an authorized service technician to assemble the elliptical exerciser, call toll-free 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires a phillips screwdriver , two adjustable wrenches , and a rubber
mallet .
See the drawings below to identify the small parts needed for assembly. The number in parentheses below
each drawing is the key number of the part, from the PART LIST on page 14. The number following the key
number is the quantity needed for assembly.
Note: Some small parts may have been preassembled. If a part
is not found in the parts bag, check to see if it has been preassembled.
4
M8 x 3 1/2” Carriage Bolt (51)–2
M8 Nylon
Locknut (57)–4
Wave Washer
(50)–2
M8 Washer
(52)–4
M8 Arc
Washer (54)–8
M8 x 1 9/16” Hex Bolt (41)–4 M8 x 5/8” Hex
Bolt (45)–6
M8 x 3/4” Hex
Bolt (26)–2
M6 Washer
(55)–2
M6 Arc
Washer (39)–4
M6 Nylon
Locknut (56)–6
M8 Cap Nut
(24)–2
M8 x 3 3/8” Hex Bolt (42)–2
M8 x 2 1/2” Hex
Bolt (40)–2
M6 x 5/8” Pocket
Screw (46)–4
Console
Screw (68)–4
ASSEMBLY