Panasonic TQBJ0349 - Manual (Page 12)

Precautions with regard to safety
12
- ENGLISH
Important
Information
Cautions when installing
Do not use under the following conditions. „
Do not set up the projector outdoors. z
The projector is designed for indoor use only.
Avoid setting up in places which are subject to vibration or shocks. z
If the projector is installed in a place where vibrations are transmitted or mounted in a car or a vessel,
vibrations or impacts will result in damage to the internal parts, causing failure. Install the product in a place
free from vibrations and impacts.
Avoid setting up in places which are subject to sudden temperature changes, such as near an air z
conditioner or lighting equipment.
Failure to observe this will result in malfunctions or the lamp life will be shortened.
See “
■
TEMP indicator” on page 76.
Avoid setting up in places which are near high-voltage power lines or near motors. z
The product will be exposed to interference if it is installed in the vicinity of high-voltage electrical power lines
or power sources.
Do not install the projector at elevations higher than 2 700 m (8 858 ft) above sea level. z
If using this projector at high elevations 1 400 - 2 700 m (4 593 - 8 858 ft) above sea level, set [ HIGH
ALTITUDE MODE] to [ON].
If using this projector at elevations lower than 1 400 m (4 593 ft) above sea level, set [ HIGH ALTITUDE
MODE] to [OFF].
Failure to observe this will result in malfunctions or the lamp life or life of other components will be shortened.
When installing and using the projector at an angle that exceeds 30° vertically, set [COOLING z
CONDITION].
Failure to observe this will result in malfunctions or the lamp life or other components will be shortened.
Lens Focus „
Do not adjust the lens focus in the initial period after switching the projector on. The high clarity projector lens is
thermally affected by the light from the light source, making the focus unstable in the period just after switching
on. Please allow a warm-up time of at least 30 minutes before adjusting the lens focus.
Be sure to ask a specialized technician when installing the product to a „
ceiling.
If the product is to be installed hanging from the ceiling, purchase an optional Ceiling Mount Attachment (For high
ceilings: Model No. ET-PKD110H, For low ceilings: Model No. ET-PKD110S). Please call a specialized technician
or contact an Authorized Service Center for installation.