Panasonic TQBJ0349 - Manual (Page 51)

ADVANCED MENU
ENGLISH -
51
Settings
INPUT RESOLUTION
Input resolution adjustment achieves the best image
when the screen flickers or halo is observed around
the contour. Set the values appropriately for the signal
resolution that is being used.
Press ▲▼ to select [INPUT 1 )
RESOLUTION].
Press <ENTER> button.
2 )
The [INPUT RESOLUTION] screen will be z
displayed.
Press ▲▼ to select [TOTAL DOTS], 3 )
[DISPLAY DOTS], [TOTAL LINES] or
[DISPLAY LINES], and the press ◄►
to adjust it.
Each item automatically displays a value in z
response to the type of the input signal. If
vertical stripes appear on the screen or the
image is partly missing, increase or decrease
the displayed value while observing the screen
to achieve the optimal value.
Note
The vertical stripes will not appear on the all white signal z
image.
The picture may be distorted during the adjusting z
operation, but this is not a fault.
The [INPUT RESOLUTION] can be adjusted only when z
RGB signal input is applied with RGB1 and RGB2 IN.
CLAMP POSITION
Use the clamp position adjustment to achieve the
optimal value when dark areas of the image are
crushed or displayed in green.
Press ▲▼ to select [CLAMP 1 )
POSITION].
Press ◄► to adjust.
2 )
The value changes from 1 to 255. z
The optimal value for the clamp position z
adjustment
If dark areas are crushed :
The optimal value is the point where the dark
area is best improved.
If the dark areas are displayed in green :
The optimal value is the point where the green
areas become black and the crushing effect is
rectified.
Note
The [CLAMP POSITION] can be adjusted only when the z
RGB signal input is applied with RGB1 and RGB2 IN.
The [CLAMP POSITION] may not be adjusted, depending z
on the signal.
FRAME RESPONSE
When 1 080/60i, 1 080/50i or 1 080/24sF signals are
entered, the video processing is simplified and the
frame delay of image is reduced.
Press ▲▼to select [FRAME 1 )
RESPONSE].
Press ◄► to switch [FRAME
2 )
RESPONSE] setting.
The setting will change as follows each time the z
button is pressed.
NORMAL FAST
NORMAL Precedes the image quality.
FAST Suppresses a time delay.
Note
Select the [NORMAL] mode to display a high- z
quality image.
If [NOISE REDUCTION] is set to [1], [2] or [3], the z
[FRAME RESPONSE] function is suppressed.
RASTER POSITION
When the scaler is set such that the image is smaller
than the display area, the image can be moved to any
position inside the display area.
Press ▲▼ to select [RASTER 1 )
POSITION].
Press <ENTER> button.
2 )
The [RASTER POSITION] screen will be z
displayed.
Press ▲▼◄► to adjust the position. 3 )