Panasonic TQBJ0349 - Manual (Page 53)

ENGLISH -
53
Settings
See z “Navigating through the menu”
( Æ page 39).
See z “MAIN MENU” and “SUB MENU”
( Æ page 40).
COLOR MATCHING
When multiple sets are used simultaneously, this
projector allows the user to correct the difference of
colors among the sets.
Press ▲▼ to select [COLOR 1 )
MATCHING].
Press ◄► to switch [COLOR
2 )
MATCHING].
The setting will change as follows each time z
◄► is pressed.
OFF 3COLORS
MEASURED 7COLORS
OFF
Color matching adjustment is not
carried out.
3COLORS
It is possible to adjust the 3colors of
[RED], [GREEN] and [BLUE].
7COLORS
It is possible to adjust the 7colors of
[RED], [GREEN], [BLUE], [CYAN],
[MAGENTA], [YELLOW] and
[WHITE].
MEASURED
Refer to “
■
Adjusting the color
matching using a colorimeter” ( Æ on
this page) for details on this mode.
J
If [3COLORS] or [7COLORS] was
selected in step 2).
Press <ENTER> button. 3 )
The [3COLORS] or [7COLORS] screen will be z
displayed.
Press ▲▼ to select [RED], [GREEN] 4 )
and [BLUE] (if [7COLORS] was
selected, select [RED], [GREEN],
[BLUE], [CYAN], [MAGENTA],
[YELLOW], and [WHITE]).
Press <ENTER> button. 5 )
The [3COLORS:RED], [3COLORS:GREEN] or z
[3COLORS:BLUE] screen will be displayed.
If you selected [7COLORS], the
[7COLORS:RED], [7COLORS:GREEN],
[7COLORS:BLUE], [7COLORS:CYAN],
[7COLORS:MAGENTA], [7COLORS:YELLOW],
or [7COLORS:WHITE] screen will be displayed.
If [AUTO TEST PATTERN] is turned [ON], the z
test pattern of the selected color is displayed.
Press ◄► to adjust the values. 6 )
These values can be adjusted from 0 (off) to z
2 048 (full gain).
Note
The effects of correcting the adjustment color: z
When tuning the correction color that is the same as the
adjustment color: the brightness of the adjustment color
changes.
RED : RED is added to or reduced from the adjustment
color.
GREEN : GREEN is added to or reduced from the
adjustment color.
BLUE : BLUE is added to or reduced from the adjustment
color.
This adjustment should be carried out by a person who is z
familiar with the projector or by a service person because
a high level of skill is required to make successful
adjustment.
Pressing <DEFAULT> button will restore the factory z
defaults for all items.
When any setting other than [OFF] has been selected z
for [COLOR MATCHING], the [COLOR TEMPERATURE]
setting is fixed at [USER1].
J
Adjusting the color matching
using a colorimeter
The [RED], [GREEN], [BLUE], [CYAN],
[MAGENTA], [YELLOW] and [WHITE] colors
can be changed to the desired hues using a
colorimeter which is capable of measuring the
chromaticity coordinates and luminance.
Inputting the current luminance and
Q
chromaticity coordinates
Press ▲▼ to select [COLOR 1 )
MATCHING].
Press ◄► to select [709MODE] or
2 )
[MEASURED].
Press <ENTER> button.
3 )
The [ z MEASURED MODE] screen will be
displayed.
Press ▲▼ to select [MEASURED 4 )
DATA].
Press <ENTER> button.
5 )
The [MEASURED DATA] screen will be z
displayed.
DISPLAY OPTION menu