Panasonic MW-20 - Manual (Page 19)

19
VQT2Z87
Operations
A
udio pla
ybac
k settings / Using the timer
To set audio playback „
1. After performing step 10 (¼P18), press [e, r] to
select “Audio Playback” and press [OK].
2. Press [e, r] to select “Audio Playback” and press
[w, q] to select “On”.
If you select “Off”, proceed to the below step 7. •
3. Press [e, r] to select “Playback Time” and press
[w, q] to select the playback time.
10 minutes/30 minutes/1 hour/2 hours/3 hours/No Limit
If the audio playback time is set longer than the length
of time from timer start time to timer end time, the
timer end time takes priority. •
4. Press [e, r] to select “Update Source/Volume” and
press [OK].
5. Press [4 IN/VOL], [3 OUT/VOL] to adjust the
volume.
(You can also press [VOLUME
4]/[VOLUME 3] on the
main unit.)
Press [iPod/ q/h] and you can play audio and confi rm
the volume.
•
Yes No
Update Timer 1 Sound Source/Volume
Select Item OK
Source : iPod
Volume : 3
Do you want to update
this setting?
You can play the audio source in this screen to check the volume.
6. Press [w, q] to select “Yes” and press [OK].
7. Press [e, r] to select “Confi rm” and press [OK].
8. Perform the steps 11 and 12 (¼P18).
To disable the set timer
1. Select “Disable This Timer” in step 6 (¼P18) and press
[OK].
2. Press [ e, r] to select “Confi rm” and press [OK].
To delete the timer setting
1. Select “Initialize This Timer” in step 6 (¼P18) and press
[OK].
2. Press [ e, r] to select “Confi rm” and press [OK].
When the timer is set
When the unit is off, the unit is automatically turned on at
the timer start time, and the timer playback starts.
At the timer end time, the unit is automatically turned off.
If the audio playback is “On”, “
z” is displayed on the
bottom right of the screen one minute before the timer
start time. (Only for “iPod Display” screen when the unit is
on)
At the timer start time, the sound is faded in to the set
volume (gradually increased) and audio is played back.
“
z” blinks during audio playback. (Only for “iPod Display”
screen)
Note
The timer less than 10 minutes is displayed with
10 minute-width on the timer setting menu screen.
The timer operates at the set time unless you set it to
disable.
The setting status such as the playback mode is refl ected
in audio playback.
The timer audio playback does not start when the menu
screen is being displayed and when audio selection screen
is being displayed.
The timer does not start even at the timer start time if the
audio selector selecting “Audio Playback” and the audio
selector selected at the timer start time are the same and if
the iPod/iPhone is being played or searched.
„
„
„
•
•
•
•
•
•
•
•