Plasmon V15 - Manual (Page 53)

Ethernet Configuration
Page 51
Table 5. Ethernet Configuration Options
Ethernet
Address
Description
Network Address Selects the method used to set the Internet Protocol
(IP) address of the library, as follows:
• Static – The library uses a fixed IP Address,
which is assigned in the IP Address field,
described below.
• DHCP – The library uses an IP address
assigned by the network DHCP (Dynamic
Host Configuration Protocol) server.
For ease of use, Plasmon recommends using a Static
IP address.
IP Address Sets the IP address of the library, which acts as a
Simple Network Management Protocol (SNMP)
device in the network.
Subnet Mask Sets the subnet (subnetwork) mask, a set of numbers
that allows routing of communication to designated
devices within the network.
Note: This option is only displayed if the network
address is set to Static.
Gateway Address Sets the default TCP/IP (Transmission Control Proto-
col/Internet Protocol) gateway address, which allows
routing of communication outside the subnet.
Note: This option is only displayed if the network
address is set to Static.