Connect the speaker cables, Drive a screw (not supplied) into the wall – Panasonic HDMI SC-HTB15 User Manual
Page 11
Getting started
11
VQT3Q59
Connect the speaker cables.
≥ To make sure that the speaker cable is connected to the correct speaker, match the color of the speaker connector with the
color of the L/R indicator on the speaker label so as not to connect the speaker cable to the wrong speaker.
≥ Insert the wire fully, taking care not to insert beyond the wire insulation.
Drive a screw (not supplied) into the wall.
≥ Use the measurements indicated below to identify the screwing positions on the wall.
≥ Leave at least 20 mm (
25
/
32
q) of space above and each side of the speaker to allow enough space for fitting the speaker.
≥ The position in the wall where the screw is to be attached as well as the screw should be capable of supporting over 33 kg
(72.8 lbs).
≥ Keep the screws out of reach of children to prevent swallowing.
Fit the speaker securely onto the screw(s) with the hole(s).
1 Insert the wire fully.
r: White
s: Blue line
2 Press into the
groove.
Push
A At least 30 mm (1
3
/
16
q)
B
‰4.0 mm (
5
/
32
q)
C
‰7.0 mm to ‰9.4 mm (
9
/
32
q to
3
/
8
q)
D Wall or pillar
E 5.5 mm to 6.5 mm (
7
/
32
q to
1
/
4
q)
F 211 mm (8
5
/
16
q)
G 388 mm (15
9
/
32
q)
H 201 mm (7
29
/
32
q)
I 14.3 mm (
37
/
64
q)
DO
DO NOT
≥ Move the speaker so
that the screw is in
this position.
≥ In this position, the
speaker will likely fall
if moved to the left or
right.
SC-HTB15PP_VQT3Q59_eng.book Page 11 Wednesday, June 8, 2011 3:33 PM