Clearing telephone numbers from the memory, Changing the sensitivity time, Resetting the baby unit – Philips SCD 469 User Manual
Page 13: Parent unit, Cleaning and maintenance, Replacement
Clearing telephone numbers from the memory
When the memory is full or when a telephone number stored in the memory is no longer correct
or required, follow the procedure below to clear telephone numbers from the memory of the baby
unit.
1
Press the M (memory) button. (Fig. 1)
M1 blinks on the display and the corresponding telephone number appears.
Press the M (memory) button until the telephone number you want to clear appears on the
display.
Press the 0 button.
Briefly press the C (clear) button on the keypad. (Fig. 11)
The memory icon (M1-M5) starts to blink and 0 disappears from the display. The telephone
number has been cleared and the memory location is free again.
5
Repeat the above steps to clear other telephone numbers.
Note:To clear all telephone numbers at once, press the RESET button. All other settings are cleared as
well. See ‘Resetting the baby unit’.
Changing the sensitivity time
1
Press the PRG button to enter the program mode.
Press the Ö button.
Ö
and 10 start to blink on the display.
Use the numeric keypad to enter a new sensitivity time between 10 and 60 seconds.
Press the OK button to confirm the setting.
resetting the baby unit
Note:If you press the RESET button, all settings are cleared from the memory of the baby unit.
1
Press the RESET button for about 5 seconds.
The baby unit gives a short beep to confirm.
When you hear a double beep, the baby unit has been reset to its default settings.
After a few seconds, M1 starts to blink on the display. The baby unit is now in Quick Install
mode.
Enter new settings, if desired.
Cleaning and maintenance
1
Clean the baby monitor with a damp cloth.
Do not immerse the parent unit and the baby unit in water and do not clean them under the tap.
replacement
parent unit
If the battery pack of the parent unit needs to be recharged more often than usual, replace it with a
new one. You can obtain a new battery pack at the shop where you bought the baby monitor.
Note:Always replace the battery pack with one of the same type: SBC EB4880, 4.8V, 800 mAh.
1
Turn the locking knob in the bottom a quarter turn (1) and slide the battery compartment
lid downwards to remove it (). (Fig. )
,
,
,
,
,
,
EngliSh
1