Panasonic CF-Y2 - Manual (Page 39)

39
T
roub
leshooting
<When the hard disk backup function has been enabled>
If you select [1] or [2], the message [The Backup function
has been enabled. If [Recovery] is executed, the Backup
function will be disabled, and your Backup data will be
lost.] appears. In this case, press
Y .
If the message [Computer must be rebooted in order to
execute [Recovery.]] appears, press
R .
9 At the confirmation message, press Y .
The operation of reinstallation for the hard disk starts auto-
matically. (The operations take about 20 minutes.)
After the reinstallation procedure completes, this screen
should appear.
10 Remove the Product Recovery DVD-ROM, and then press
any key.
The computer will be shut down.
11 Turn on the computer, and press F2 while [Pana-
sonic] boot screen is displayed.
The Setup Utility will start up.
If the password has been set, enter the Supervisor Pass-
word.
12 Press F9 .
At the confirmation message, select [Yes] and press
Enter . (The Setup Utility settings will return to their
default values. Even the security settings with the excep-
tion of the password(s) will return to their default values.)
13 Press F10 .
At the confirmation message, select [Yes] and press
Enter .
14 Perform the setup procedure for Windows by following the
instructions on the screen (
page 13 -14).
15 Run the Setup Utility and change the settings where neces-
sary.
16 If you can connect to the Internet, perform Windows Up-
date.
Do not interrupt the reinstallation procedure before
completion, for example by turning off the computer
or pressing Ctrl + Alt + Del , as this may
prevent Windows from starting up, or may cause data
to be lost so that the reinstallation procedure cannot
be executed.
CAUTION
-----------------------------------------------------------------------
[Recovery] is complete.
Windows(R) XP Professional install wizard will start after reboot.
Please remove the Product Recovery DVD-ROM, and turn off the computer.
------------------------------------------------------------------------
<Changing the drive letter>
You can change the drive letter for the DVD-ROM & CD-R/
RW drive or hard disk drive by the following steps.
Drive letters can only be changed when two or more parti-
tions have been created on the hard disk drive. The name of
the C: drive cannot be changed.
We recommend that you make these changes before install-
ing applications.
1 Select [start] - [Control Panel] - [Performance and Mainte-
nance] - [Administrative Tools] - [Computer Management].
2 Select [Disk Management] from [Storage].
3 Right click on the partition of the hard disk or the name of
the DVD-ROM & CD-R/RW drive and select [Change Drive
Letter and Paths...].
4 Select [Change].
5 Select [Assign the following drive letter] and select the new
drive letter, and then select [OK].
6 At the confirmation message, select [Yes].