ProForm PFEL05807.0 - Manual (Page 5)

5
ASSEMBLY
To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included tools, assembly requires a Phillips screwdriver , an adjustable
wrench , and a rubber mallet .
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly. IMPORTANT: Some small parts may
have been preassembled. If a part is not in the hardware kit, check to see if it has been preassembled.
M4 x 16mm
Self-tapping
Screw (79)–10
M10 Spacer
(76)–2
M6 Split
Washer (88)–8
M10 x 20mm x
2mm Washer
(81)–4
M10 x 25mm x
1.5mm Washer
(83)–8
M8 x 42mm Button Bolt (71)–4 M6 x 16mm Phillips
Screw (87)–8
M10 x 23mm Shoulder
Screw (80)–8
M8 x 16mm Button
Screw (95)–3
M8 Nylon
Locknut (96)–4
Wave Washer
(93)–6
M10 Split
Washer (72)–2
M10 x 15mm Patch
Screw (82)–4
M10 x 62mm Button Bolt (97)–2 M10 x 48mm Button Screw (78)–2
M4 x 65mm Screw (91)–4
M4 x 16mm
Screw (86)–4
M4 x 16mm
Flange Screw
(84)–2
M4 x 12mm
Flange Screw
(73)–6
M10 x 35mm Shoulder
Screw (94)–2