Getting started, Step 2: setting up the tv – Philips DVD Micro Theatre MCD702 User Manual

Page 17

Advertising

English

Step 1:

Inserting batteries into
the Remote Control

Open the battery compartment.

Insert two AAA batteries following the
indications (+/-) inside the compartment.

Close the cover.

Using the Remote Control to operate
the Player

Aim the Remote Control
directly at the remote sensor
(IR) on the front panel.

Do not put any objects
between the Remote Control
and the DVD Player while
operating the DVD Player.

CAUTION!
–

Remove batteries if they

are exhausted or if the Remote Control
is not being used for a long time.
–

Do not use old and new or different

types of batteries in combination.
–

Batteries contain chemical substances,

so they should be disposed of properly.

Step 2:

Setting up the TV

IMPORTANT!
–

Make sure you have completed all the

necessary connections. (See
“Connecting TV”).
–

In order for a DVD disc to play on this

Player, the colour system of the Disc, the
TV and the DVD Player should match.

Switch the DVD system on and then select
DISC source. (See “Switching the system
on/off”).

Turn on the TV and set to the correct video-in

channel. You should see the blue Philips DVD
background screen on the TV.

➜

Usually these channels are between the

lowest and highest channels and may be called
FRONT, A/V IN, or VIDEO. See your TV manual
for more details.

➜

Or, you may go to channel 1 on your TV, then

press the Channel down button repeatedly until
you see the Video In channel.

➜

Or, the TV Remote Control may have a

button or switch that chooses different video
modes.

➜

Or, set the TV to channel 3 or 4 if you are

using an RF modulator.

Getting Started

STANDBY-ON

IR SENSOR

pg001-036_MCD700_37_Eng

2005.7.7, 13:22

Advertising