ProForm Fusion PFSY3415.0 - Manual (Page 13)

13
24. Attach the Seat (19) and the Seat Base (91) to
the Seat Frame (6) with two M6 x 25mm Screws
(60), an M6 x 87mm Screw (68), and an M6
Washer (78).
Hook the Seat Frame (6) onto the Upright (3) at
the indicated location.
24
19
6
68
91
78
60
3
26. Slide two Foam Pads (21) onto the Seat Frame
(6).
Slide a Pad Tube (20) through a hole in the Leg
Lever (7). Slide two Foam Pads (21) onto the Pad
Tube.
25. Attach the Bumper (49) to the Leg Lever (7) with
an M4 x 16mm Screw (70).
Apply grease to an M10 x 71mm Bolt (67). Attach
the Leg Lever (7) to the Seat Frame (6) with the
Bolt and an M10 Nylon Locknut (73).
Do not
overtighten the Bolt; the Leg Lever must be
able to pivot easily.
25
26
6
73
67
Grease
7
70
49
21
27. Slide an Arm Pad Base (83) and an Arm Pad (84)
onto the VKR Frame (82). Attach the Arm Pad
and Base to the Frame with two M6 x 73mm
Screws (103) and two M6 Washers (78).
Repeat this step on the other side of the VKR
Frame (82).
27
84
83
78
82
103
103
20
21
21
21
7
6