Peripheral Electronics PGHTY1 - Manual (Page 7)

5
6. iPod Operation
Entering Mode Select Menu
Press the “AM/SAT” button to switch to AM then again to switch back to SAT.
Turn the rotary knob to scroll through the available sources. Once “IPOD” is
displayed, press PRESET 3 to select the displayed mode.
Next Track
Turn the rotary tune knob clockwise to advance to the next track.
Previous Track
Turn the rotary tune knob counter-clockwise to move back to the previous track.
Fast Forward
Press PRESET 2 repeatedly to fast forward the song that is playing.
Rewind
Press PRESET 1 repeatedly to rewind the song that is playing.
Entering “BROWSE” Menu / Select
Press PRESET 3 to enter the “BROWSE” menu or to make a selection while in the
“BROWSE” menu.
Menu UP
Press PRESET 4 to move up one folder in the “BROWSE” menu.
Exit Browse menu
After 10 seconds of inactivity, the Browse menu will time out and return to normal
operation.
Steering Wheel Controls
Press the “/\” button to advance to the next track.
Press the “\/” button to return to the previous track.
6. Plug in the male connectors on the PGHTY1 harness into the 12-pin port on the
back of the radio. Next, connect the factory 12-pin harness (if present) into the female
connector on the PGHTY1 harness. Be sure to make a firm connection but do not force
it. Plug the Black micro-fit 24-pin connector on the PGHTY1 harness into the PXAMG
Media Gateway box.
7. To complete the installation secure the Media Gateway (PXAMG) and HD Radio
tuner (HDRT if equipped) into the cavity in the dash behind the radio. Be sure that the
cables and interface modules are not near moving parts or sharp metal edges as they
may damage the cables. To prevent rattling noises inside the dash, use zip ties, tape,
or other fasteners to mount the interfaces securely.
8. With all connections made, reconnect the vehicle’s battery, insert the key into the
ignition, and turn the vehicle on. Check for proper operation of the Media Gateway and
HD Radio tuner before reinstalling the factory dash panels.
9. Note: The first time you access the Gateway, your radio may display “DEV INIT”
while the device is initializing. If this is displayed, please wait one minute then cycle the
ignition off and on. Then access SAT mode again to begin normal gateway operation.