Philips CD175 - Manual (Page 16)

16
1
Press R during a call.
The first call is put on hold. »
2
Dial the second number.
The number displayed on the screen is »
dialed out.
Answer a second call
Note
This service is network dependent. •
When there is a periodical beep to notify you
of an incoming call, you can answer the call in
these ways:
1
Press R and to answer the call.
The first call is put on hold, and you »
are now connected to the second call.
2
Press R and to end the current call
and answer the second call.
Toggle between two calls
1
Press R and .
The current call is put on hold, and you »
are now connected to the other call.
Make a conference call with
the external callers
Note
This service is network dependent. Check with •
the service provider for additional charges.
When you are connected to two calls, press R,
then .
The two calls are combined and a »
conference call is established.
Answer a call
When the phone rings, press to answer
the call.
Note
The caller ID service is available if you have •
registered to the caller ID service with your
service provider.
Tip
When there is a missed call, the handset •
displays a notification message.
Turn off the ringer for all incoming
calls
There are two ways to turn off the ringer:
1
Press and hold in standby mode.
» displays on the screen.
2
When the phone rings, press BACK.
Adjust the earpiece volume
Press or to adjust the volume during a call.
The earpiece volume is adjusted and the phone
is back to the call screen.
Mute the microphone
1
Press during a call.
The handset displays » [MUTE ON].
The caller cannot hear you, but you »
can still hear his voice.
2
Press again to unmute the microphone.
You can now communicate with the »
caller.
Make a second call
Note
This service is network dependent. •
EN
IFU_CD170-175_05_EN.indd 16 2009-12-17 17:30:39