Panasonic DMC-TS25 - Manual (Page 24)

VQT4N50 (ENG)
24
Battery Charger (Panasonic DE-A91B):
Information for your safety
Equipment mobility:
Movable
Battery Pack (lithium-ion) (Panasonic DMW-BCK7PP):
Information for your safety
Crash resistance
perfomance The test method of the camera is in compliance with
“MIL-STD 810F Method 516.5-Shock”
¢ .
¢ “MIL-STD 810F Method 516.5-Shock” is the test method
standard of the U.S. Defense Department, which specifies
performing drop tests from a height of 122 cm (4 feet), at 26
orientations (8 corners, 12 ridges, 6 faces) using 5 sets of
devices, and passing the 26 orientation drops within 5
devices.
(If failure occurs during the test, a new set is used to pass the
drop orientation test within a total of 5 devices)
• Panasonic’s test method is based on the above “MIL-STD 810F
Method 516.5-Shock”. However, the drop height was changed
from 122 cm (4 feet) to 150 cm (5 feet) dropping onto 3 cm
(0.1 feet) thick plyboard. This drop test was passed.
(Disregarding appearance change such as loss of paint or
distortion of the part where drop impact is applied.)
There is no guarantee of not breaking or malfunctioning
under all conditions.
Dustproof
performance Equivalent to IEC 60529 “IP6X”.
Input: 110 V to 240 V, 50/60 Hz, 0.2 A
Output: 4.2 V, 0.43 A
Operating
temperature:
0 oC ¢ to 40 oC (32 oF ¢ to 104 oF)
¢ The battery cannot be recharged in a temperature less than
0 oC (32 oF). (The [CHARGE] indicator blinks when the
battery cannot be recharged.)
Voltage/capacity: 3.6 V/680 mAh
DMC-FT25&TS25P-VQT4N50_eng.book 24 ページ ２０１２年１１月１５日 木曜日 午前１０時４４分