Philips FW-V28 - Manual (Page 23)

3139 116 20021
23
English
5 Press CLOCK•TIMER again to store the
setting.
™ The clock starts.
• To exit without storing the setting, press
Ç on the system.
Notes:
– During clock setting, if no button is
pressed within 90 seconds, the system
will exit clock setting mode
automatically.
– When a power interruption occurs, the
clock setting is erased.
Timer Setting
• The system can switch on to VCD,
TUNER or TAPE 2 mode automatically at
a preset time. It can serve as an alarm
to wake you up.
• Before setting the timer, make sure the
clock is set correctly.
• The timer will always be switched on
once it is set.
• The volume of the timer will
increase from the minimum level
until the volume level before the set
is switched to standby mode.
1 Press and hold CLOCK•TIMER for more
than 2 seconds to select timer mode.
™ "12:00 AM " or "00:00" or the last
timer setting starts flashing
depending on whether you have
selected 12- or 24-hour mode.
™ The TIMER flag starts flashing.
™ The selected source is lit while other
available sources are flashing.
2 Press VCD, TUNER or TAPE to select
the desired source.
• Before selecting VCD or TAPE, make
sure a disc or tape is loaded in the disc
tray or tape deck 2.
3 Press à or á on the system to set
the hour for the timer to start.
4 Press í or ë on the system to set the
minute for the timer to start.
5 Press CLOCK•TIMER to store the start
time.
™ The timer is now set.
™ The TIMER flag remains on the
display.
• At the preset time, the timer will be
activated.
™ The selected source will be played.
Notes:
– During timer setting, if no button is
pressed within 90 seconds, the system
will exit timer setting mode
automatically.
TIMER
– If the source selected is TUNER, the last
tuned frequency will be switched on.
– If the source selected is VCD, playback
will begin with the first track of the disc
tray 1 or other trays if disc tray 1 is
empty. If all the disc trays are empty, the
TUNER will be selected instead.
– The timer will not activate if a recording
is in progress.
To switch off the TIMER
1 Press and hold CLOCK•TIMER for more
than 2 seconds.
2 Press Ç on the system to cancel the
timer.
™ The timer is now switched off.
™ The display will show "CANCEL"
and the TIMER flag disappears.
To start the TIMER again (for the same
preset time and source)
1 Press and hold CLOCK•TIMER for more
than 2 seconds.
2 Press CLOCK•TIMER again to store the
start time.
™ The timer is now on.
™ The TIMER flag appears on the
display.
Untitled-1 31/05/2001, 11:35 AM 23