Porter-Cable PCK3030SP - Manual (Page 15)

15- ENG D27927
When performing maintenance, you may be exposed to hot
surfaces, water pressure, or moving parts that can cause
serious injury or death!
Before performing any maintenance or repair, disconnect spark plug wire, let
engine cool and release all water pressure. The engine contains flammable
fuel. DO NOT smoke or work near open flames while performing
maintenance.
To ensure efficient operation and longer life of your pressure washer, a routine
maintenance schedule should be prepared and followed. If the pressure washer is
used in unusual conditions, such as high-temperatures or dusty conditions, more
frequent maintenance checks will be required.
ENGINE
Consult the Engine Owners Manual for the manufacturer's recommendations for
any and all maintenance.
MAINTENANCE
To Check Oil:
1. Remove dipstick/oil plug from pump and
wipe clean.
2. Insert dipstick/oil plug fully into pump,
then remove it.
3. Oil level is correct when oil covers the
lower 1/2 inch of end of dipstick/oil plug.
How To Change Pump Oil
1. Loosen dipstick/oil plug.
2. Place a container under the oil drain plug.
3. Remove oil drain plug.
4. After oil is drained replace oil drain plug. Tighten securely.
5. Remove dipstick/oil plug and fill with recommended oil. See the Pump Oil
Chart for the correct amount and type of oil.
6. Replace dipstick/oil plug and tighten securely.
Annovi Reverberi (XMV) 30W non detergent 13.5 oz.
Dipstick/oil plug
Oil
Drain
Plug
PUMP TYPE OIL TYPE
OIL
CAPACITY
PUMP OIL CHART
PUMP
NOTE: The pump was filled with oil at the factory.
1. Change pump oil after the first ten (10) hours of operation and every fifty (50)
hours thereafter.