Patton electronic ONSITE 2800 - Manual (Page 59)

Introduction 59
OnSite 2800 Series User Manual 5 • T1/E1 port configuration
Introduction
This chapter provides an overview of the T1/E1 WAN port, their characteristics and describes the configura-
tion tasks.
The model 2803 has a T1/E1 WAN port on the rear panel of the unit. The T1 version (Model 2803T) has an
RJ-48C connector, and the E1 version (Model 2803K) offers the user connectivity via either the RJ-48C or
dual coaxial connectors. Both models can be configured for T1 or E1 operation.
The configurable parameters for the T1/E1 port are type (T1 or E1), clock mode (or source) (master or slave),
line code (AMI, HDB3, or B8ZS), framing (CRC-4, ESF, or unframed), line-build-out (for T1 only) and
encapsulation (channelized or HDLC).
A further feature is the creation and configuration of channel-groups.
T1/E1 port configuration task list
This section describes the configuration tasks for the T1/E1 port.
• Enable/Disable T1/E1 port
• Configuring the T1/E1 port type
• Configuring T1/E1 clock mode
• Configuring T1/E1 line code
• Configuring T1/E1 framing
• Configuring T1 line build out (LBO) (T1 only)
• Configuring E1 impedance/connector
• Configuring T1/E1 application mode
• Configuring T1/E1 LOS threshold
• Configuring T1/E1 encapsulation
• Create a Channel-Group
• Configuring channel-group timeslots
• Configuring channel-group encapsulation
• Entering HDLC configuration mode
• Configuration HDLC CRC-type
• Configuring HDLC encapsulation
Enable/Disable T1/E1 port
By default, the T1/E1 port is disabled. The following command is used for enabling or disabling it.