Panasonic KX-A272 - Manual (Page 14)

14 | Operating Instructions
Serial Repeater ID programming continued.
• Ensure that the repeater is switched OFF. (both LED’s are OFF)
• Power ON the repeater.
• Assign the repeater to a base by following either the manual or automatic
registration process.
• Bring the repeater into close range of the repeater on the parent level (i.e. when
assigning a repeater to chain-level 3, the repeater must be brought into close range
with the repeater already set to chain-level 2.).
• Press the switch the corresponding number
of times to set the chain-level.
(i.e. 3 times = chain-level 3 etc.).
The red LED flashes a number of times
corresponding to the chain level.
NB: Pressing the switch 4 or more times
corresponds to chain-level 1.
• After two minutes from power ON, the new chain-level and Radio Fixed Part Identity
(R.F.P.I.) are then stored into the repeaters memory, and the repeater returns to
normal operation.
• Please note : This function is not available for domestic DECT appliances, only
PBX.
QUQX00130YA_01_A 20/1/04 6:41 pm Page 14