Philips HTS5506/F8 - Manual (Page 44)

EN - 44
D Note for “IP Address”, “Subnet Mask”, “Default
Gateway”, “Primary DNS” and “Secondary
DNS”
• The range of input numbers is between 0 and 255.
• If you enter a number larger than 255, the number will
automatically be reset to 255.
• When you enter a wrong number, select “Clear” to
clear. (The number will be reset back to “0”.)
• If you want to enter a 1 or 2-digit number in one cell,
press [ ] to move on to the next cell.
D Note for “Proxy Address” and “Proxy Port”
• The range of input numbers for the port number is
between 0 and 65535. (If you enter a number larger
than 65535, it will be regarded as 65535.)
• For proxy port, certain ports might be closed, blocked
or unusable depending on your network environment.
• Choose a connection speed in accordance with your
network environment.
• When the settings are changed, the network
connection may be disabled depending on the device.
„ Wireless
If you connect this unit to the Wi-Fi network, select
“Wireless” and set up necessary settings.
Please make a note of your Wi-Fi network name (SSID) and
its WEP / WPA key before proceeding with the setup.
Auto Scan
Search for Wi-Fi networks automatically and select the
Wi-Fi network name (SSID) from the list.
1. Follow steps 1 to 2 in “Auto Setup” on page 42.
2. Use [
] to select “Wireless”, then press [OK].
3. Use [ ] to select “Auto Scan”, then press [OK].
• This unit will start searching for Wi-Fi networks
automatically.
4. The result of Wi-Fi network searching will be displayed.
Use [ ] to select the appropriate Wi-Fi network
name (SSID), then press [OK].
• If you select an SSID without “ ”, please go to step 6.
5. “Access Point Setting (Auto Scan)” screen will appear.
Enter the WEP / WPA key of the selected Wi-Fi
network using cursor buttons, number buttons and
color key, then press [Red].
• If you do not know the WEP / WPA key for your
Wi-Fi network, ask your ISP or the person who set
up your Wi-Fi network.
6. Use [ ] to select “Continue”, then press [OK].
7. Use [ ] to select “Auto Setup” or
“Manual Setup”, then press [OK].
• If you select “Auto Setup”, follow step 5 in
“Auto Setup” on page 42.
• If you select “Manual Setup”, follow steps 3 to 12 and
14 to 16 in “Manual Setup” on page 42.
D Note
• The internal wireless LAN supports following
specifications.
- Wi-Fi standards
:IEEE 802.11 b/g/n
- Frequency spectrum :2.4 GHz
- Security protocol
:WEP / WPA / WPA2
Manual Entry
Set up the connection to the Wi-Fi network manually by
entering the Wi-Fi network name (SSID).
1. Follow steps 1 to 2 in “Auto Scan” on page 44.
2. Use [
] to select “Manual Entry”, then press
[OK].
3. “Access Point Setting (Manual Entry)” screen will
appear.
Enter the SSID using cursor buttons, number buttons
and color key, then press [Red].
Rescan
Cancel
Access 1
Access 2
Access 3
Access 4
Access 5
Access 6
Access 7
Please select the
access point.
XXXXXXXXXX_
a/A/@
Access Point Setting (Auto Scan)
Please input the WEP/WPA key with keypad or software keyboard.
Done Cancel Clear
WPA-PSK(AES)
Access 1
XXXXXXXXXX
●
●
●
Please confirm the
setting.
Rescan
Continue
Cancel
SSID
Security
WEP/WPA Key