Planet Technology VIP-320 - Manual (Page 43)

Note: x is the registered handset number and y is the registered DECT base.
Un-register / Reset your DCT-100
• Press the INT button before power on the handset.
• Power on the handset, and DO NOT release the INT button till the LCD displays "F->clear
Subs"
• Press the down button to clear the handset settings.
• Power off, power on handset again, the handset will display "Not Sub", and it is now not registering
to any DECT base.
Call transfer between DCT-100
•
During handset 1 (HS1) conversation, press the INT button and enter the desired
handset number. (in this sample, we press the 2 to transfer the call to HS2)
•
The desired handset 2 (HS2) will ring, press the button to answer the call.
•
At this moment, press the button on handset 1 (HS1), the voice call is now
transferred to the handset 2 (HS2).
•
If the handset 2 not answer the call, and you’d like to cancel the transfer. On handset 1
(HS1), press the INT button, the call will be re-connected handset 1 (HS1) again.
Conference call between DCT-100
•
During conversation, press the INT button, and there will be "Intercom" message
displayed on the LCD screen.
•
Press the handset number you'd like to add in the voice conferencing. At this moment,
you may hear the ringing tone from the destination handset.
•
Start voice conversation with the destination handset, and you may now press the # key
for 3 seconds, and the destination handset will be joined in the voice conferencing.
VIP-320 DECT base settings
The DECT base settings in VIP-320 have been optimized for most voice communication
applications. It is not necessary to change the parameters in most occasions.
43