Panasonic BB-HCM311A - Manual

HomeLogic LLC 100 Hoods Lane Marblehead, MA 09145 Phone (781) 639-5155 Fax (781) 639-9677
OneHome Camera Integration Note
Manufacturer: Panasonic
Model Number(s): BB-HCM311A, BB-HCM331A, KX-HCM110A
OneHome Versions: 3.0 (all builds), 4.0 (all builds)
Comments: Network Camera (EasyConfig.exe version 1.0.21)
Document Revision Date: 9/6/2006
O
VERVIEW AND
S
UPPORTED
F
EATURES
Installing the Panasonic camera can be broken down into the following steps:
1. Install cameras at desired locations, and pull power and Cat5 cabling as needed. Refer to the
Panasonic documentation for mounting details.
2. Connect the cameras electrically to the home network and configure the cameras. See Camera
Configuration.
3. Integrate the cameras into the OneHome system and test proper operation. This step is outlined
in HomeLogic Configuration Details.
T
HESE CAMERAS SUPPORT THE FOLLOWING FEATURES :
Pan / Tilt: The camera can be turned to see various locations.
Built-in Audio: There is a built-in microphone as well as a jack for an external microphone. Audio from
the Panasonic cameras is supported in version 4.0 and later.
Presets: Some of these camera models also support presets, allowing the user to store predefined
locations such as a driveway or pool. This feature requires OneHome software version 4.0 or later.
C
AMERA
C
ONFIGURATION
The camera configuration is done with software provided by Panasonic, which must be run from a
computer with Windows also connected to the same network as the camera.
The software program from Panasonic is EasyConfig.exe: the version we checked is shown at the top.
I
MPORTANT N OTES
1. Cameras must be configured one at a time: If you are installing more than one camera, setup
the first one completely before powering up subsequent cameras.
2. Setup the camera within 20 minutes: Initial settings must be made within 20 minutes of the
camera being turned on. If the camera has been powered up for more than 20 minutes, cycle
power to the camera before proceeding.
3. DON’T LOSE THE CAMERA PASSWORD: During setup you will create a user name and
password, which are required to make any other changes in the future. If you lose the user name
or password you will have to factory reset the camera and repeat this entire procedure.
4. DEFAULT USER NAME / PASSWORD: For Panasonic cameras, our default user name is
Administrator and our default password is password.