Ope ration, Cautions – Pyramid Technologies PX-7KX User Manual
Page 4
OPE RATION:
1
INSERT
AC POWER PLuG INTO A
IIOV
VOLT
AC OUTLET.
2
CONNECT THE POWER CORD OF YOUR EQUIPMENT (13.5V - 14 1VDC) TO THE
OUTPUT BINDING POST TERMINALS ON THE FRONT OF THE UNIT BE SURE THAT
POLARITY IS CORRECT. THE RED POSITIVE (+) TERMINAL AND BLACK NEGATIVE
(-) TERMINAL ARE MARKED. REVERSAL OF POLARITY. MAY DAMAGE YOUR
EQUIPMENT.
3
TURN SWITCH TO "ON". RED LIGHT IN SWITCH WILL ILLUMINAfE
4
THE INPUT POWER IS PROTECTED BY THE FUSE WHICH IS LOCATED AT THE REAR
OF THE UNIT AND CAN BE REPLACED BY UNSCREWING THE FUSE HOLDER IF THE
FUSE IS BURNT OUT. DO NOT USE A FUSE LARGER THAN
• •
AMPS USE OF
HEAVIER FUSE MAY RESULT IN DAMAGING TO THIS UNIT
(
• •
SEE NOTE)
5. THIS UNIT HAS ELECTRONIC OVERLOAD PROTECTION WITH INSTANT AUTOMATIC
RESET FUNCTION IF OUTPUT IS OVERLOADED. THE OUTPUT POWER WILL
AUTOMATICALLY SHUT OFF. RELEASE POWER CORD O
f
YOUR EQUIPMENT FROM
THE OUTPUT TERMINALS AND CHECK THE ACTUAL POWER RATING OF YOUR
EQUIPMENT. THIS UNIT
WILL
AUTOMATICALLY RESET INSTANTLY
6.
OVER TEM PERATURE PROTECTI ON CIRCUITRY IS USED IN
PS-7KX/BKX
T O PREVENT OVER HEAT DAMAGE UNIT WI LL BE SHUT DOWN
MIN UTES AFTER
15
MINUTES( M IN.
)
AT
100%
RATED LOAD.
25
MINU TES( MIN.) AT
00%
RATED LOAD.
NOTE PS-3KX: 1. 5 AM P
PS-4KX : 1 0
AMP
PS-7KX: 1-5
AMP
PS-SKX : 1.5
AMP
CAUTIONS:
1
DO NOT USE WITH EQUIPMENT REQUIRING MORE THAN RATING AMPS
2
DO NOT USE OUTDOORS. DO NOT EXPOSE UNIT TO RAIN. MOISTURE. WATER OR
ANY OTHER LIQUIDS
3
DO NOT REMOVE COVER IN ANY CASE. RETURN TO DEALER FOR REPAIR IF
DAMAGED.
4.
THIS UNIT HAS
A
SPECIAL BUILT-IN FEATURE THAT WILL SHUT THE UNIT OOWN
IF MARKED AMPERAGE IS EXCEEDED. THIS WILL AVOID BURN-OUT OF YOUR
EQUIPMENT AND OF UNIT. IF UNIT DOES CONSISTENTLY SHUTDOWN. THIS MEANS
YOU ARE DRAWING TOO MUCH AMPERAGE. RETURN UNIT TO PLACE OF
PURCHASE AND UPGRADE TO NEXT AVAILABLE UNIT OFFERING HIGHER
AMPERAGE. PLEASE DO NOT BYPASS OR ALTER THIS CIRCUIT AS IT IS THERE
TO PROTECT YOU. ANY ALTERATION OR MISUSE WILL VOID YOUR WARRANTY.
"DANGER"
HIGH VOLTAGE
REFER TO QUALIFIED TECHNICIAN FOR SERVICE_
-4-