Panasonic PV-D4761 - Manual (Page 25)

25 [email protected]
To Replace program...
To Clear program...
Review, Replace or Clear Program Contents:
(Recording is not in progress)
or
CANCEL : ADD / DLT
SELECT 1-8 :
ENTER : SET
EXIT : PROG
P DT START STOP CH SPD
1 7 9 : 00A 12 : 00A 08 SP
2 8 10 : 00P 12 : 00P 02 SP
3 10 8 : 00P 9 : 00P 10 SP
4 SU 9 : 00P 10 : 00P L
1 LP
CANCEL : ADD / DLT
SELECT 1-8 :
ENTER : SET
EXIT : PROG
P DT START STOP CH SPD
1 -- -- : -- -- : -- -- --
2 8 10 : 00P 12 : 00P 02 SP
3 10 8 : 00P 9 : 00P 10 SP
4 SU 9 : 00P 10 : 00P L
1 LP
Press ADD/DLT.
*Important: If a remote control button does not work when pressed, press
the VCR button on the remote and try the button again.
1
3
4
Press
to select number and
press SET
to display.
To cancel Timer Recording
in progress...
Repeat Step 3 (p. 24)
to set new programs.
Press PROG/VCR+ button
to end the program.
Hold down STOP on VCR mode for
a few seconds to cancel Timer
Recording.
(The “TIMER” indicator goes out
on Multi Function Display.)
• Any future daily or weekly recording
will be performed as programed.
Notes
Repeat steps 1 ~ 2 on page 24.
2
7 SUN SUN 9 9:00A 00A 12 12: 00A 00A 08 08
TODAY
----------------------------------------
DATE START STOP CH
SP
SE SELE CT START START DAT ATE
SELECT :
SET : SET BACK :
END : PROG
• If you are using Cable Box, the VCR’s channel for Timer Recording must be set to
the Cable Box output channel and Cable Box must be manually set to the desired
channel. Cable Box power must be left on.
• 2 minutes before Timer Recording is performed, “PLEASE PREPARE FOR TIMER REC”
appears and Timer Indicator flashes.
Be sure a cassette with record tab is loaded and DECK is in Stop mode.
• If a power interruption occurs while programming the timer, the timer program(s) may be
canceled. If “TIMER PROGRAMS WERE LOST DUE TO POWER INTERRUPTION”
appears on-screen, please reenter the timer programs.
• If the start time for Timer Recording comes up during recording and playing back,
Timer Recording will not be performed.
Important notes when using DSS Receiver
• When recording programs via DSS Receiver, DSS Receiver must be left on.
• When recording programs via an antenna or cable, DSS Receiver must be turned off.
VCR
Operation