Panasonic KX-TG6671 - Manual (Page 25)

Special programming
Alarm
An alarm sounds at the set time for 3 minutes
once or daily. Alarm can be set for each handset.
Important:
R Set the date and time beforehand (page 12).
Handset
1 MMENUN#720
2 MbN: Select the desired alarm option. a
MSELECTN
Off Turns alarm off. Go to step 7.
Once An alarm sounds once at the set
time.
Daily An alarm sounds daily at the set
time. Go to step 4.
3 Enter the desired month and date. a MOKN
4 Set the desired time.
5
MAM/PMN: Select “AM” or “PM”. a MOKN
6
MbN: Select the desired alarm tone. a
MSELECTN
R We recommend selecting a different ringer
tone from the one used for outside calls.
7
MSELECTN a MOFFN
R When the alarm is set, is displayed.
Note:
R To stop the alarm, press MOFFN or place the
handset on the charger.
R When the handset is in use, the alarm will not
sound until the handset is in standby mode.
Silent mode
Silent mode allows you to select a period of time
during which the handset will not ring for outside
calls. This feature is useful for time periods when
you do not want to be disturbed, for example,
while sleeping. Silent mode can be set for each
handset.
Important:
R Set the date and time beforehand (page 12).
R We recommend turning the base unit ringer off
(page 14) in addition to turning the silent mode
on.
R If you have set the alarm, the alarm sounds
even if the silent mode is turned on.
Turning silent mode on/off
Handset
1 MMENUN#238
2 MbN: Select the desired setting. a MSAVEN
R If you select “Off”, press MOFFN to exit.
3 Enter the desired hour and minute you wish to
start this feature.
4 MAM/PMN: Select “AM” or “PM”. a MOKN
5 Enter the desired hour and minute you wish to
end this feature.
6 MAM/PMN: Select “AM” or “PM”.
7 MSAVEN a MOFFN
R When the silent mode is set,
is
displayed.
Changing the start and end time
Handset
1 MMENUN#237
2 Continue from step 3, “Turning silent mode on/
off”, page 25.
Changing the handset name
Each handset can be given a customized name
(“Bob”, “Kitchen”, etc.). This is useful when you
make intercom calls between handsets. You can
also select whether or not the handset name is
displayed in standby mode. The default setting is
“No”. If you select “Yes” without entering any
handset name, “Handset 1” to “Handset 6” is
displayed.
Handset
1 MMENUN#104
2
Enter the desired name (max. 10 characters;
see the character table, page 17).
R If not required, go to step 3.
3 MSAVEN
4 MbN: Select the desired setting. a MSELECTN
2 times
5 MOFFN
For assistance, please visit http://www.panasonic.com/help 25
Programming