Philips HALO SURFACE H2220 - Manual (Page 4)

3
INSTALLING YOUR TELEPHONE
CHOOSING THE POSITION FOR THE BASE STATION
To reduce any risks of interference, avoid placing the base station less than 1 metre from another
electrical device (telephone, television, computer, etc.). The base station must be placed on a flat
surface.
Avoid placing the base station:
- in a damp room,
- near a heat source,
- near obstacles like thick walls or metal structures.
INSERTING / REPLACING THE BATTERIES
Your handset is powered by 2 rechargeable AA/R6
batteries. If you need to replace them you should use
PHILIPS RC NC-P or Saft RC6 batteries.
1 ð Press the top of the battery cover and slide it
downwards.
2 ð Insert the batteries, taking care to respect the
marked polarities.
3 ð Close the cover.
The batteries contain cadmium and should be disposed of in accordance with
the regulations in force concerning the disposal of waste.
Never use non-rechargeable batteries. The manufacturer disclaims all
responsibility if these recommendations are not respected.
CONNECTING THE TELEPHONE
At the back of the base station:
1 ðConnect the mains adapter cable to the base station, then plug
the mains adapter into the wall socket.
2 ðConnect the telephone cable to the base station and then to the
wall socket.
ðPlace the telephone handset on the base station and allow the
batteries to charge for at least 12 hours.
Only use the cables supplied with the product.
FITTING THE COLOUR CLIP
1 ðInsert the clip from the top first.
2 ðFirmly press on the clips (in the arrow direction) until they
lock.
3 ðTo remove the colour clip, pull it out from the “Philips “
marking.
1 2
Cd
ang6120.qxd 31/05/99 15:36 Page 3