Premier Mounts WMK-027 User Manual

Page 8

Advertising
background image

Page 8

Installation Instructions

Please review the Operator’s Manual that came packaged with your projector before attaching the upper mounting

bracket. The correct throw distance (the distance from the projector to the screen) must be determined prior to mounting

the projector.

Throw Distance Calculation

Step 1. Refer to the projectors Users Manual to

determine the distance from the lens to the

front of the screen.

Step 2. Measure the distance from the front of the

lens to the center of the PDS-PLUS (see

diagram).

Front Mounted Lens

For front-mounted lenses, add distance (Y)

to distance listed in projector Users Manual.

Rear Mounted Lens

For rear-mounted lenses, subtract disance (Y) from

the distance listed.

Step 4. Use a tape measure to mark the appropriate

distance on the WMK-027. This

will be where the center of the mounting

bracket will be located.

WMK-027

MAKE SURE THE PROJECTOR ARM IS FULLY SEATED BEFORE RELEASING THE UNIT.

Step 4. Locate the two (2) lock mounting points on the projector arm. These two points will be aligned with the lock mounting

points on the wall plate.

Step 5. Using a security wrench, insert and tighten two (2) M5 x 12mm security head screws.

DO NOT OVERTIGHTEN THE SCREWS.

Lock Mounting Point

M5 x 12mm Security Head Screw

Screwdriver/Security Wrench

If installing WMK-027, please refer

to Page 10 before continuing.

Front Lens

Rear Lens

Calculations

X = Manufacturers recommended

throw distance

Z = Distance from wall to face of

whiteboard/screen

Front Lens Throw Distance =

(X + Y + Z)

Rear Lens Throw Distance =

(X - Y + Z)

Advertising