Panasonic WV-Q151C - Manual (Page 11)

11
F R ONT
LOC
K
F R O N T
F R ONT
LOC
K
F R O N T
Projections
Hooks for the
decorative cover
*1 position on the
rear side
START
END
F R O N T
FR ON T
LOCK
Mounting base
Camera mounting plate
Align A with A
Align B with B
Fixing screw to be used for cover fall prevention
14. Mount the camera mounting plate on
the mounting base.
q Align the marks ( A to A and B to
B) between the camera mounting
plate and mounting base.
w Mount the camera mounting plate on
the mounting base with aligning g of
the camera mounting plate with
"STARTh" of the mounting base.
e Turn the camera mounting plate until
g of the camera mounting base
aligns with "ENDh" of the mounting
base.
r Tighten the 3 screws that were
removed in Step 2.
(Recommended tightening torque:
1.6 N·m {16 k
gf·cm})
Important: Do not let the cables be
caught during installation work.
15. Mount the decorative cover.
q Mount the decorative cover on the
camera mounting plate with engag-
ing the projections of the decorative
cover with the hooks for the decora-
tive cover.
w Turn the decorative cover clockwise
while pressing the projections
upward and the cover is locked.
Important: The mark, "FRONT", shall be
aligned with the Panasonic logo.
16. Tighten the fixing screw to be used for
cover fall prevention.
(Recommended tightening torque:
1.6 N·m {16 k
gf·cm})
Note: When the camera lens is pointed in the horizontal direction, the inner shell interferes
with the camera’s view, and consequently about upper half of the monitor screen is
hidden in the WIDE mode.