Registration of input signal data, Registration of new data, Renaming the registered signals – Panasonic PT-DW100E User Manual

Page 43: English – 43, Basic operation, Press enter. 2, Press enter. 3

Advertising
background image

ENGLISH – 43

Basic Operation

Registration of input signal data

The input signal data must be registered because
it is not registered on shipment of the projector.

MENU

Press to display the MAIN
MENU screen.

Press to select “SIGNAL
LIST”.

Press to display the
“REGISTERED SIGNAL
LIST” menu.

The memories extend

over 12 pages (A to L with
8 data items each, giving
a total of 96 memories).

ENTER

MAIN MENU

PICTURE

POSITION
ADVANCED

MENU

DISPLAY

LANGUAGE

DISPLAY

OPTION

PROJECTOR SETUP

P IN P
TEST

PATTERN

SIGNAL LIST

SECURITY
NETWORK

MENU

SELECT

SUB MENU

Registration of new data

When a new signal is supplied, press MENU on the
remote control or operating section of the main unit.
When its data has been registered, the “MAIN MENU”
screen is displayed.

Note

The data of 96 input signals can be registered.

The signals supporting the installed input module

are input and their data registered.

The memories are numbered over 12 pages (A to L:

8 data items can be registered on each page), and
the data is registered in the unused memory with
the lowest number. If all the memories are used, the
data of the old signals is overwritten in sequence.

The names of the registered data are automatically

determined by the input signals and memory
numbers.

If a menu is being displayed, the new signals will be

registered at the instant they are input.

Renaming the registered signals

Press

▲▼◄ ► to select the

1.

signal whose details are to be
displayed.

REGISTERED SIGNAL LIST

A1:SVGA72-A1 RGB1

−−−

A2:SVGA72-A2 RGB1

−−−

A3:SVGA72-A3 RGB1

−−−

Press ENTER.

2.

The “REGISTERED SIGNAL STATUS” screen

will be displayed.

REGISTERED SIGNAL STATUS

NAME
MEMORY NO
INPUT
fH
fV
SYNC.STATE

SVGA72-A2
A2
RGB1

48.08kHz
72.17Hz

H(POS)
V(POS)

The data items including the input signal name,

memory number, input terminal, frequency and
sync signal are automatically identified and
displayed.
When MENU is pressed, the “REGISTERED

SIGNAL LIST” screen is restored.

Press ENTER.

3.

The “RENAME” screen will be displayed.

▲▼◄►
ENTER

DEFAULT

MENU

Advertising
This manual is related to the following products: