Panasonic PT-DW100E - Manual (Page 54)

54 – ENGLISH
Adjusting the picture (continued)
Press
◄► to switch “COLOR
3.
TEMPERATURE”.
The setting will change as follows each time •
◄► is pressed.
DEFAULT
HIGH
USER1
MIDDLE
USER2
LOW
When any setting other than “OFF” has been •
selected for colour matching, the COLOR
TEMPERATURE setting is fixed at “USER1”.
“DEFAULT” cannot be selected when the picture •
mode has been set to “USER”.
To further adjust toward the
„
desired white balance
Select “USER1” or “USER2” in 4.
Step 3.
Press ENTER. 5.
The “WHITE BALANCE” screen will be •
displayed.
WHITE BALANCE
WHITE BALANCE HIGH
WHITE BALANCE LOW
Press
▲▼ to select “WHITE
6.
BALANCE HIGH” or “WHITE
BALANCE LOW”.
Press ENTER. 7.
The “WHITE BALANCE HIGH (LOW)” screen •
will be displayed.
WHITE BALANCE HIGH
RED
GREEN
255
255
Press
▲▼ to select “RED”,
8.
“GREEN” or “BLUE”.
Press
◄► to adjust the level.
9.
Item Operation Adjustment
Adjustment
range
RED
Press ►
button.
Deepens red.
Maximum
value
HIGH : 255
LOW : 127
Minimum
value
HIGH : 0
LOW : -127
Default
HIGH : 255
LOW : 0
Press ◄
button.
Weakens red.
GREEN
Press ►
button.
Deepens green.
Press ◄
button.
Weakens green.
BLUE
Press ►
button.
Deepens blue.
Press ◄
button.
Weakens blue.
Note
All colours will not be displayed properly unless •
adequate adjustment is made. If the adjustment
does not look suitable, you can press DEFAULT to
return the setting for the selected item only to the
factory default setting.
The colour temperature cannot be adjusted for the •
internal test pattern (p. 85). Be sure to project the
input signal when adjusting the colour temperature.
Gamma setting
This switches the gamma mode.
Press
▲▼ to select “GAMMA”.
1.
COLOR TEMPERATURE
GAMMA
SHARPNESS
DEFAULT
DEFAULT
0
Press
◄► or ENTER.
2.
The “GAMMA” individual adjustment screen •
will be displayed.
GAMMA
CHANGE
DEFAULT
Press
◄► to switch “GAMMA”.
3.
The setting will change as follows each time •
◄► is pressed.
DEFAULT
2.6
USER1*
2.5
USER2*
2.2
* “USER1” and “USER2” appear when the setting
was set with a control command from the serial
terminal.
Note
“DEFAULT” cannot be selected when the picture •
mode has been set to “USER”.