Panasonic CQ-VX100W - Manual (Page 14)

TILT
CQ-VX100W
DIMMER DIM
TUNE/TRACK
MUTE MAP
SOURCE
POWER VOL
PUSH SEL
AV1 IN
OPEN
MUTE
SOURCE
TILT OPEN
Operations
13
14 CQ-VX100W
English
General
[MUTE]
[OPEN]
[SOURCE] (POWER)
[TILT] [VOL]
–
( a page 12) [SOURCE ]
General Operations
DVD VTR
RADIO CH-C
END
– [SOURCE ]
Power
ON :
Source selection
Note:
¡The sources AV1 and
AV2 provide the audio
and video from the
devices connected to
AV1 IN and AV2 IN of
this unit respectively,
and the source Ext. In
provides the audio and
video from the device
connected to EXT
VIDEO IN of this unit via
the expansion module
(CY-EM100N, option).
¡If there is no external
sources connected,
AV1/AV2 mode can be
set to skip. (
a page
31)
[OPEN] ¡Press once to open. Press again to close.
Display Open/Close
Note:
¡When the display is opened or closed, a loud beep sounds three times.
¡If the unit stops halfway, press [OPEN] again to draw it all the way out.
¡Opening/closing the display can be done when the power is off.
–
[SOURCE ]
Power
OFF :
Preparation: Turn your car’s ignition key to the ACC or ON position.
…… Touch/Press and hold for more than 2 seconds
RADIO (AM/FM)
( a page 24)
DVD (DVD/VCD (Video CD)/CD/MP3/DivX)
( a page 18)
AV1 ( a page 26)
AV2
Ext. In
HUB1
HUB2
HUB3
HUB4
( a page 26)
( a System
Upgrade
Guidebook)
Sources connected
to the Expansion
Module
(CY-EM100N)
When the Expansion
Module (CY-EM100N,
option) is connected.
(
a System Upgrade
Guidebook)