Panasonic DMC-LZ7 - Manual (Page 61)

Advanced (Recording pictures)
61
VQT1C60
Press [ ] to display the [REC] mode
menu and select the item to set. (P55)
∫ About the jitter/movement detection
demonstration screen
Press 1 on the [STABILIZER] screen to
display the jitter/movement detection
demonstration screen. (You cannot take
pictures while the demonstration screen is
displayed.) Press
1 to exit the
demonstration screen.
A: Jitter detection demonstration
B: Movement detection demonstration
• The jitter/movement detection
demonstration screen is an
approximation.
• The camera also detects the movement of
the subject when automatically setting the
ISO sensitivity in intelligent ISO sensitivity
mode [
] (P41) and [SPORTS] (P44),
[BABY1]/[BABY2] (P46) and [PET] (P47)
in scene mode only.
• The stabilizer function may not be
effective in the following cases.
– When there is a lot of jitter.
– When the zoom magnification is high.
– In digital zoom range.
– When taking pictures while following a
moving subject.
– When the shutter speed becomes
slower to take pictures indoors or in dark
places.
Be careful of camera jitter when you press
the shutter button.
• In simple mode [ ], the setting is fixed
to [MODE1] and in [STARRY SKY] (P48)
in scene mode it is fixed to [OFF].
• In motion picture mode [ ], [MODE2]
cannot be set.
Press [ ] to display the [REC] mode
menu and select the item to set. (P55)
When burst is set to [ON], it is activated
while the shutter button is pressed.
• You can only take one picture when the
flash is activated.
• The burst speed becomes slower
halfway. The exact timing of this depends
on the type of card, the picture size and
the quality.
• You can take pictures until the capacity of
the built-in memory or the card is full.
• The burst speed becomes slower if the
ISO sensitivity (P41, 58) is set to [ISO400]
or higher.
• The burst speed may become slower in
dark places because the shutter speed
becomes slower.
[STABILIZER]
Detecting jitter and compensating
for it
[MODE1]
(
)
The stabilizer operates
continuously and can assist
during photo composition.
[MODE2]
(
)
The jitter is compensated for
when the shutter button is
pressed. There is a greater
stabilizing effect.
[OFF]
(
)
When the stabilizer is not
desired.
MENU
SET
EXIT
JITTER, SUBJ. MOVE DEMO.
CANNOT BE DISPLAYED
IN REC MODE
[BURST]
Taking pictures using burst
MENU
SET
VQT1C60ENG.book 61 ページ ２００７年１月１１日 木曜日 午後６時４９分