Philips AJ301DB User Manual

Page 7

Advertising
background image

CONNECTING AN EXTERNAL DEVICE

You can listen to the sound of the connected external device through your
AJ301DB’s speakers.

1 Press TUNER/AUX twice to select AUX mode.
2 Use the supplied AUX-IN cable to connect AJ301DB’s AUX IN jack to an

AUDIO OUT or headphone jack on an external equipment (such as CD player, or
VCR).

MAINTENANCE & SAFETY

• Install the unit near the AC outlet and where the AC power plug can be easily

reached.

• The apparatus shall not be exposed to dripping or splashing.
• Do not expose the set to humidity, rain, sand or excessive heat caused by

heating equipment or direct sunlight.

• To clean your set, use a soft damp cloth or chamois leather. Do not use cleaning

products, which contain benzene, thinner, etc. as these may harm the housing.

• Where the MAINS plug or an appliance coupler is used as the disconnect

device, the disconnet device shall remain readily operable.

• Batteries (battery pack or batteries installed) shall not be exposed to exces-

sive heat such as sunshine, fire or the like.

SPECIFICATIONS

Power Consumption ........................................................................................24 W
Output power .....................................................................................2 x 6 W RMS
Dimensions (w x h x d) .........................................................161 x 191 x 164 (mm)
Weight..........................................................................................................1.34 kg

TROUBLESHOOTING

If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this

will invalidate the guarantee. Do not open the set as there is a risk of
electric shock!

No sound

– Volume not adjusted
• Adjust the volume
– The set is muted.
• Press”MUTE” on the remote control to active playback sound.
Display error / no reaction to any controls

– Electrical malfunction
• Unplug the power cord, then re-plug.
Intermittent crackling sound during FM reception

– Weak signal
• Extend and position the pigtail aerial

The alarm does not function

– Alarm time/ mode not set
• See SETTING THE ALARM
– Volume too low for radio
• Increase the volume

Dock operation

– The menu navigation or photo playback of the docked player cannot be

carried out through the buttons on AJ301DB or its remote control.

• The buttons on AJ301DB and its remote control can control playback of audio

contents only. To navigate the menu, use the controls on the docked player.

– Some buttons on AJ301DB and its remote control have no function.
• The buttons (

2;, ¡1, 2™ and VOLUME) function only.

AJ301DB Eng 1/9/04 19:36 Page 7

Advertising
This manual is related to the following products: