Panasonic 12-808 - Manual (Page 6)

6
OPERATION
USING THE CLOCK
You can use the clock to keep track of the
time in two different time zones.
Follow these steps for each time zone to set
the clock in that zone.
1. Press POWER ON/OFF to turn off the
radio, then press DUAL TIME to select
Time 1 or Time 2.
1 or 2 appears .
2. Press MEM/TIME. The display flashes.
3. Within 5 seconds, repeatedly press or
hold down HOUR to set the hour. Then
repeatedly press or hold down MIN to
set the minute.
Notes:
• PM appears when the clock displays a
PM hour. AM appears when the clock
displays an AM hour.
• When you change the minute setting for
a time zone, the radio automatically
changes the minute setting for the other
time zone.
To view both time zones while the radio is
on, hold down DUAL TIME for 3 seconds.
The time zone last displayed appears. Press
DUAL TIME again to view the other time
zone.
TUNING THE RADIO
1. Turn VOL to its lowest setting, then lift
and fully extend the antenna.
2. Press POWER ON/OFF to turn on the
radio. The last tuned frequency appears.
3. Slide BAND AM/FM/SW/TV/WX to the
desired band. If you select AM, MW
appears.
4. If you set AM/FM/SW/TV/WX to FM,
SW, TV, or WX, set SENS (sensitivity) to
LOC to receive strong local signals, or
set it to DX to improve reception of a
weak station.
5. Repeatedly press TUNING UP or
DOWN to tune to the desired station.
Note: To automatically tune the radio to
the next strong signal, hold down TUN-
ING UP or DOWN for about 2 seconds.
Or, use the number keys to directly enter
the band (AM/FM/SW only) and fre-
quency you want to tune. For example,
to tune FM station 97.1, slide AM/FM/
SW/TV/WX to FM then press FM 9 7 1
then FM again. Enter the entire AM/SW
frequency even if the last number is 0.
ERR appears if the frequency is out of
the selected range.
6. Adjust VOL to a comfortable listening
level.
7. Slide TONE to HIGH or LOW to suit
your listening preference.
8. To turn off the radio, press POWER ON/
OFF again.
12-808.fm Page 6 Wednesday, November 3, 1999 9:56 AM