ParaBody Hip Sled System - Manual (Page 15)

FIGURE 11
STEP 11:
15
• SECURELY assemble the two PAD SUPPORTS (3) to the CARRIAGE (16) as shown in FIGURE 11 using two 1/2 X 3-1/4”
BOLTS (41), four 1/2” WASHERS (32), and two 1/2” LOCK NUTS (33).
• SECURELY assemble two SHOULDER PADS (17) to the PAD SUPPORTS (3) on the CARRIAGE (16) as shown in FIGURE 11 using
four 3/8 X 3” BOLTS (37), four 3/8” LOCK WASHERS (30), and four 3/8” WASHERS (29). (NOTE: THAT HOLES IN PADS ARE
OFF-SET TO ONE SIDE)
41 1/2 X 3-1/4”
3/8 X 3” 37
33
29 26
17
32
30
3 SURFACE TO BE EVEN