Panasonic KX-FL611AL - Manual (Page 16)

1. Introduction and Installation
14
2 Pull the tension plate forward ( 1) and attach
the paper tray cover (
2), then push the
tension plate back ( 3).
Note:
L Do not place the unit in an area where the
paper tray may be obstructed (i.e., by a wall,
etc.).
L Keep this surface ( 4) away from walls etc.
more than 50 mm to let the unit cool down.
To remove the paper tray
Pull the paper tray forward in the direction of the
arrow.
1.7 Paper stacker
Line up the slots ( 1) in the paper stacker with
the pegs (
2) on the bottom of the unit, then
insert the two tabs of the paper stacker into the
slots on the unit (
3).
Note:
L Do not place the unit in an area where the
paper stacker may be easily bumped into.
L Document and recording paper will be
ejected from the front of the unit. Do not place
anything in front of the unit.
L The paper stacker can hold up to
approximately 100 sheets of printed paper.
Remove the printed paper before the paper
stacker becomes full.
1
2
3
4
2
1
3
FL611AL-PFQX2169ZA-en.book Page 14 Thursday, February 24, 2005 11:37 AM