Polycom RMX 2000 - Manual (Page 22)

Chapter 2-First Time Installation and Configuration
2-8
3 In the lan.cfg file, modify the following parameters using the
information supplied by your network administrator. Make sure that
there are no extra spaces at the end of each line.
—
Management (Control Unit) IP Address
—
Management (Control Unit) Subnet Mask
— Management (Control Unit) Default Gateway
—
Shelf Management IP Address (Switch)
— Shelf Management Subnet Mask
—
Shelf Management Gateway
4 Save the file.
Procedure 3: First-time Power-up and Connection to MCU
To power-up for the first time using the USB key:
1
Insert the USB key containing the modified IP addresses in USB port
on the RMX’s back panel.
2 Power the RMX On.
The parameters in the lan.cfg file are uploaded from the USB key to
the RMX’s memory and applied during the power-up sequence.
Power-up is complete when the red HD Active LED starts blinking.
3 Remove the USB key.