Palm E2 - Manual (Page 540)

Tungsten™ E2 Handheld 519
CHAPTER 25 Customizing Your Handheld
Using the full-screen writing area
0
1
Open the entry where you want
to enter information:
a. Open an application.
b. Select a record or tap New.
2
Position the cursor where you want the characters to appear, and do any of the
following:
• Write lowercase Graffiti 2 letters anywhere on the left side of the screen.
• Write numbers anywhere on the right side of the screen.
• Write uppercase letters in the middle of the screen.
• Write the Punctuation Shift stroke before writing symbols and other special
characters.
• Use buttons and other controls that appear on the screen by tapping and
holding the button or control until it activates.
Done
Before You Begin [ ! ]
Turn on Writing Area
Preferences as described
in the previous section.
Tip
Right after you write a
character, your handheld
interprets a quick tap on
the screen as a period
character. If you want to
tap a button, either wait a
few seconds or
temporarily turn off full-
screen writing by tapping
the shaded box in the
lower-right corner. The
shaded box changes to a
box outline when Writing
Area Preferences are off.
Shaded box
indicates Writing
Area is on