Panasonic WV-CU550C - Manual (Page 9)

9
The installation described below should be made by qualified service personnel or system installers and should
conform to all local codes.
■ Replacing the Side Panels with the optional WV-Q62 Rack Mounting
Brackets
1. Remove both the left and right side panels of the System Controller by removing four screws.
2. Remove the Palm-rest located on the front of the System Controller by removing two screws.
3. Place the Rack Mounting Brackets on both sides of the System Controller and tighten with the four supplied screws.
4. Install the System Controller with Rack Mounting Brackets in the rack by using four screws (procured locally).
Remove screws.
Tighten
screws.
Rack Mounting Bracket
Side Panel
Rack Mount Screws
Rack Mount Screws
Palm-rest
INSTALLATION
■ System Controller for the WJ-FS616 Video Multiplexer
When combined this System Controller with the optional WJ-FS616 Video Multiplexer, place the display sheets and label on the
controller shown below.
Refer to the Operating Instructions of WJ-FS616 for further details.