Plantronics CS60-USB DECT - Manual (Page 7)

USAGE INSTRUCTIONS
6
DIAGRAM KEY
HEADSET
1 Microphone
2 Speaker
3 Talk Button
4 Volume/Mute Control
5 On-line Indicator
6 Charge Contacts
7 Battery Door
DESK CHARGER
8 AC Power Adapter
9 AC Power Adapter Port
10 Headset Docking Cradle
11 Charge Contacts
12 Status Indicator
13 Charge Indicator
14 Stand
15 Stand Pegs
16 Ringer Switch On/Off
17 USB Connector
18 Subscription button access hole
(paperclip required)
1. GETTING STARTED
To use your Plantronics CS50-USB/CS60-USB Headset System, please follow these
simple steps:
1. Install the hardware.
2. Install the software.
3. Charge your headset battery.
4. Choose your headset wearing style.
5. Carry out the initial set-up
INSTALLING THE CS50-USB/CS60-USB BASE UNIT
To install the base-unit, attach the stand by inserting the Stand Pegs into the locating
holes on the underside of the base unit. Connect to the USB connector shown in Fig.
2 on page 1 to a free USB port on your computer. A USB hub can be used but you
should ensure it can supply sufficient power (250mA) to charge the headset. This
will create the finished assembly (refer to Fig.3, page 1). Alternatively, the Velcro
strips included can be used to attach the base unit to a PC monitor. The optional AC
Power Adapter can be installed as shown in Fig. 2.1