Panasonic C3301U - Manual (Page 15)

15
14
E
N
G
L
I
S
H
CQ-C3401U/C3301U
Display Change
Press [DISP] to change the display as follows.
Note:
¡
“– – – –” is displayed when there is no information.
¡ “UPDATING” is displayed when channel information is
updated.
Channel Preset
Up to 6 channels can be stored in each of the XM1, XM2
and XM3 band selections.
With this operation, a channel can be manually stored in
the preset memory.
q Select a band and channel. (
a Previous page)
w Press and hold one of the preset buttons from [1] to [6]
until the display blinks once.
Note:
¡
New channels overwrite existing saved channel after
this procedure.
Preset Channel Calling
q Select a band. ( a Previous page)
w Press one of the preset buttons from [1] to [6].
Note:
¡
Because preset memory setting is performed with serv-
ice IDs in each channel, a channel may switch to anoth-
er that has been stored under the same service ID when
calling up a preset channel. However, broadcasting con-
tents are the same as what the stored channel provides.
Category Setting
Press and hold [BAND] for more than 2 seconds to
switch category mode ON or OFF.
(Category mode ON)
¡ Enables category switching
¡ Enables channel selection only within the catego-
ry selected by category switching
Category Selection
q Press [}] or [{] to display the category name. (CAT
ON)
w Press [}] or [{] while the category name is dis-
played to select a category. Seeking will start.
Direct Channel Selection
(Only for remote control unit)
Example: Channel number 5
q Press [#].
w Press [5]
e Press [BAND] (SET).
Note:
¡
The previous screen reappears if a nonexistent channel
is selected.
¡ “OFF AIR” is displayed and the previous screen reap-
pears in a few seconds if an off-the-air channel is
selected.
Artist name
Channel name
( )
(Data loading)
( )
(Data loading)
Song title
( )
(Data loading)
Category name
( )
(Data loading)
Clock time
Band/Channel
(Default)
appears at category mode ON