Preparation, Remote control unit main unit, Cancellation of demonstration clock setting – Panasonic C3301U User Manual
Page 9: Warning, Caution, Preparation before initial use, Battery replacement
9
8
E
N
G
L
I
S
H
CQ-C3401U/C3301U
Preparation
Warning
¡
Keep a battery away from children to avoid the risk of
accidents. If an infant ingests a battery, please seek
immediate medical attention.
Caution
¡
Remove and dispose of an old battery immediately.
¡
Do not disassemble, heat or short a battery. Do not
throw a battery into a fire or water.
¡
Follow local regulations when disposing of a battery.
¡
Improper use of a battery may cause overheating, an
explosion or ignition, resulting in injury or a fire.
Note:
¡
Battery Information:
Battery Type: Panasonic lithium battery (CR2025)
(Included in the remote control)
Battery Life: Approximately 6 months under normal use
(at room temperature)
The demonstration message appears for initial
use.
q Set your car’s ignition switch to the ACC or ON position.
The demonstration screen appears.
w Press [DISP].
The demonstration screen is canceled, and no more
appears.
Note:
¡
I
f you would like to turn on the power and make the
demonstration message appear, press and hold [SRC]
(PWR) for more than 4 seconds.
Remote Control Unit
Main Unit
The 12-hour system is used for the clock.
q Press [SRC] (PWR) to turn on the power.
w Press [DISP].
Clock display
e Press and hold [DISP] for more than 2 seconds.
Hour blinks
r Adjust the hour.
[[]: put forward hour.
[]]: put back hour.
Hour entered
t Press [DISP].
Minute blinks
y Adjust the minute.
[[]: put forward minute.
[]]: put back minute.
Minute entered
u Press [DISP].
Completed
Note:
¡
“ADJUST” is displayed before adjusting the clock.
¡
Press and hold [[] or []] to change numbers rapidly.
Cancellation of demonstration
Clock Setting
OPEN
DISC
SCROLL
PWR
MUTE
RANDOM
SCAN
REPEAT
CLOCK
FO
LD
ER
VO
LU
M
E
P
U
S
H
SE
L
T
U
N
E
/T
R
AC
K
CQ-C3401U
2
1
3
SRC
SQ
4
5
6
DISP
BAND
APM
SRC
DISP
[SRC] (PWR: Power)
[DISP] (Display)
[]] [[]
(Hour/minute adjustment)
Preparation Before Initial Use
Pull the insulation film out from the
backside of the remote control gently.
Battery Replacement
q
w
q Remove the battery holder with the
remote control unit placed on a flat
surface.
q Stick your thumbnail into the
groove and push the holder in the
direction of the arrow at the same
time.
w Pull it out in the direction of the
arrow using a tough pointed object.
2
3
w Put a battery in the case with (+)-side
facing up.
e Put the case back.
Tough pointed
object
Back side